RM3,113.00
Audio Technica 40 Series AT4053b Hypercardioid Condenser Modular Microphone
Price RM3,113.00
Brand Audio-Technica
Size (L x W x H) 10 cm x 20 cm x 10 cm
Availability In Stock
Quantity
Description

This versatile studio performer may be used with confidence in a wide variety of professional miking applications. Featuring direct-coupled balanced outputs for clean signals in high-output conditions, the AT4053b is totally free of the distortion associated with conventional transformer-coupled outputs. And its fast response to transients contributes to the open, transparent reproduction of even the most difficult-to-capture instruments.

  • Specially engineered to meet the most critical acoustic requirements of professional recording, broadcast and sound reinforcement
  • Hypercardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source
  • Direct-coupled, balanced output results in a clean signal even under high-output conditions
  • Transformerless circuitry virtually eliminates low-frequency distortion and provides superior correlation of high-speed transients
  • Switchable 80 Hz hi-pass filter and 10 dB pad
  • Rugged turned-brass microphone housing for enduring dependability
  • State-of-the-art design and manufacturing techniques ensure compliance with Audio-Technica's stringent consistency and reliability standards
Element Externally polarized (DC bias) capacitor
Polar Pattern Hypercardioid
Frequency Response 20 - 20.000 Hz
Open Circuit Sensitivity -34 dB (19.9 mV) re 1V at 1 Pa
Impedance 50 ohms
Maximum Input Sound Level 145 dB SPL, 1 kHz at 1% T.H.D.; 155 dB SPL, with 10 dB pad (nominal)
Low Frequency Roll Off 80 Hz, 18 dB/octave
Switches Flat, roll-off; 10 dB pad (nominal)
Dynamic Range 129 dB, 1 kHz at Max SPL
Signal-to-Noise Ratio 78 dB, 1 kHz at 1 Pa
Phantom Power Requirements 48V DC, 4.8 mA typical
Weight 127g
Dimensions 155.0 mm (6.10") long, 21.0 mm (0.83") maximum body diameter
Output Connector Integral 3-pin XLRM-type
Accessories Included AT8405a stand clamp for 5/8"-27 threaded stands; windscreen; protective carrying case